![]() If used, this final redirection comprises a Call Forwarding action. (The next hunt party varies depending on the current hunt algorithm.) ***Hunting thus ignores the Call Forward No Answer (CFNA), Call Forward Busy (CFB), or Call Forward All (CFA) settings for the attempted party (Line Group member Phones).Ĭisco Unified Communications Manager offers the ability to redirect a call when hunting fails (that is, when hunting terminates without any hunt party answering, due either to exhausting the list of hunt numbers or to timing out). When a call extends to a hunt party from these lists and the party fails to answer or is busy, hunting resumes with the next hunt party. Hunting allows Cisco Unified Communications Manager to extend a call to one or more lists of numbers, where each such list can specify a hunting order that is chosen from a fixed set of algorithms. The concept of hunting differs from that of call forwarding. The following describes how the Call Forward settings on individual Hunt member phones are ignored when presented a call via the Hunt feature. The normal way to control this then is via the Hunt Group Logout of member phones combined with the Hunt Pilot level forward settings. You have to keep in mind that a call that has routed via the Hunt Pilot will always ignore the CFWD Settings on Hunt Group Member phones. So, the fact that 10 are receiving the calls via a Hunt Group has a great bearing on this config. Any ideas or help on this would be very much appreciated. Everything appears as if it is going properly, but I'm stuck on the part of actually telling CUCM to forward the call to the Unity mailbox. I've run the voicemail port config wizard. I have already imported the 2 users into Unity. I'd like to be able to set it up so that each DN rings on the IP phone say 6 times then goes to a Unity voicemail box setup for that user. ![]() They are both part of a hunt list (broadcast) so that when incoming calls arrive, both phones will ring simultaneously. I've been reading lots of documentation on CUCM and Unity, but I know Unity Express isn't what I need and haven't found info on the very basics of setting up voicemail for CUCM users. Now I am trying to setup voicemail extensions for the users. ![]() I'm using MGCP (Cisco 3745 with 2FXO as gateway). I have 2 DNs assigned to users and Cisco IP phones. I am trying to setup a test deployment of CUCMB 6.01. ![]()
0 Comments
Leave a Reply. |